An Intelligent Method for Bearing Pad Flatness Inspection Based on UAV-Enabled 3D Reconstruction
The flatness of bearing pads directly affects structural load transfer safety. However, conventional total station-based inspection methods suffer from limited spatial sampling, low inspection efficiency, and high safety risks associated with working at height. To address these limitations, this paper proposes UAV-FIBP (Unmanned Aerial Vehicle-based Flatness Inspection for Bridge Pads), an automated and intelligent method for pad flatness assessment utilizing UAV-based 3D reconstruction. By designing a close-range, multi-orbit circumnavigational UAV flight path and acquiring high-overlap imagery (85% forward and 80% side overlap), a millimeter-accurate 3D model is generated via photogrammetry, achieving a high-density point cloud of ≥200 points/cm2 on the pad surface. Following point cloud denoising and region-of-interest segmentation using the Random Sample Consensus (RANSAC) algorithm, Principal Component Analysis (PCA) is employed to fit a reference plane. A dual-parameter evaluation framework is subsequently introduced: the root mean square (RMS) deviation quantifies local surface roughness, while the maximum elevation difference is derived from the angle between the normal vectors of the fitted plane and the horizontal plane, thereby enabling a comprehensive assessment of global inclination. Validation experiments conducted on laboratory-scale setups and real construction sites (involving four bridge pads) demonstrate that the proposed method achieves deviations ≤ 2 mm compared to total station measurements, satisfying the requirements stipulated in the Standards for Quality Inspection and Verification of Highways (JTG F80/1-2017). Results indicate that UAV-FIBP enables non-contact, full-coverage, and automated flatness inspection, significantly improving inspection efficiency and construction safety. This work establishes a scalable technical pathway for intelligent bridge construction.