Mechanical Behaviour and Flow Characteristics of Reservoir Sandstone Under Deep Triaxial Stress Conditions
The development of deep oil and gas reservoirs has become a key focus in the exploration and exploitation of hydrocarbon resources. To elucidate the mechanisms governing the flow evolution of reservoir sandstone under deep, high-triaxial stress conditions, this study takes the deep reservoir sandstone of a specific block as its subject. Using a true triaxial rock mechanics–seepage coupled testing system to simulate the in situ high-triaxial stress environment. Synchronous testing of the sandstone’s mechanical and seepage properties was conducted, and a staged permeability model for the elastic and damaged zones of the sandstone was developed and experimentally validated. The results indicate that, under deep, high-triaxial stress conditions, the total stress–strain behaviour of sandstone is divided into compaction, elastic deformation, yield and post-failure stages. The mechanical behaviour exhibits a ‘compression–unloading–failure’ pattern, whilst permeability follows a U-shaped evolution characterised by an ‘exponential decline–sudden increase–stabilisation’ trend; furthermore, the influence of damage on flow properties is irreversible. The intermediate principal stress exerts a significant strengthening effect on the mechanical properties of sandstone; as it increases, the peak strength and residual strength of the sandstone rise, whilst post-peak brittleness decreases and ductility increases. The intermediate principal stress is a key factor regulating the evolution of permeability. During the elastic stage, the initial permeability of the sandstone decreases as the stress increases, and the rate of exponential decay accelerates; during the damage stage, the post-peak permeability decreases as the stress increases, and the irreversible closure of pores caused by true triaxial stress makes it difficult for the post-peak permeability to recover to its initial value. The coefficient of determination for the permeability model fitted to the elastic stage is greater than 0.9, whilst that for the damage stage ranges from 0.76 to 0.85. These models effectively characterise the quantitative relationship between permeability and strain under different stress conditions, demonstrating good reliability and applicability. The research findings provide experimental evidence for elucidating the coupled relationship between mechanics and flow in sandstone under deep, high-triaxial stress conditions, as well as for predicting flow behaviour in deep reservoirs and designing development schemes.