Thermal Distortion Behavior and Microstructural Evolution of Ti-6Al-1.3V-0.9Fe Alloy

Abstract

The Ti-6Al-4V alloy is widely used in aerospace and deep-sea applications due to its exceptional strength and corrosion resistance. However, its application is often constrained by high deformation resistance and a narrow hot-working temperature window, primarily attributed to its heat and mass transfer characteristics. To address these limitations, a novel Ti-6Al-1.3V-0.9Fe alloy was designed with an equivalent molybdenum content. In this study, Gleeble thermal simulation tests were conducted to investigate the impact of Fe on the hot deformation behavior under various conditions and to identify the optimal processing window for this alloy. The effects of deformation temperature and strain rate on the flow stress curves and peak stress were systematically analyzed, along with the role of Fe in microstructural evolution during hot deformation. The results demonstrate that the addition of Fe significantly refines the grain size of the Ti-6Al-1.3V-0.9Fe alloy. As expected, the flow stress decreases with increasing deformation temperature and increases at higher strain rates. Under high-temperature and low-strain-rate conditions, the alloy exhibits steady-state flow behavior, indicating improved hot workability. Based on the constitutive modeling, the apparent activation energy (Q) for hot deformation was calculated to be 503.81 kJ/mol. Finally, the optimal hot-working parameters for the Ti-6Al-1.3V-0.9Fe alloy were identified as a temperature range of 760 °C to 860 °C and a strain rate between 0.01 and 0.16 s−1.