Skip to content
Open access

Experimental and simulation study on mechanical properties of steel fiber coal gangue concrete

Sep 2026 · Scientific Reports · 0 citations

Abstract

Coal gangue aggregate has high water absorption and a porous microstructure, both of which can reduce the mechanical performance of coal gangue concrete (CGC). This study examined whether hooked steel fibers can compensate for this strength loss and improve the mechanical behavior of steel fiber-reinforced coal gangue concrete (STCGC). Seven mixtures were prepared by varying the coal gangue replacement ratio (0%, 25%, 50%, and 75%) and, at 50% replacement, the steel fiber content (0%, 0.5%, 1.0%, and 1.5%). In total, 210 specimens were tested at 7 d, 14 d, and 28 d by cube compression, splitting tensile, axial compression, and elastic modulus tests. Scanning electron microscopy and ABAQUS mesoscopic simulation were used to interpret the failure mechanism and verify the compressive response. The results show that increasing coal gangue replacement reduces strength because of the porous and weak aggregate structure, whereas steel fibers improve crack resistance and post-cracking integrity. Compared with the 50% CGC mixture, steel fiber addition increased the average cube compressive strength, splitting tensile strength, axial compressive strength, and measured elastic modulus by 2.26%, 24.61%, 23.26%, and 59.47% (a mixture-specific result under the present test conditions; see Results for interpretation), respectively. Under the specific baseline of 50% coal gangue replacement, the 1.0% steel fiber mixture achieved the most balanced mechanical performance among the tested series Strength-conversion equations and stress-strain constitutive relationships were fitted for the tested mixtures. The simulated cube compressive strengths followed the experimental trend, indicating that the mesoscopic model can reproduce the compressive failure pattern of STCGC within the scope of the present mixtures. This study provides a test-calibrated basis for using steel fibers to improve the mechanical performance of coal gangue aggregate concrete.

Read PDF

Similar papers

Open access Sep 2026

Strength Evolution of Concrete with Different Coal Gangue and Fly Ash Contents

To explore the application feasibility of coal gangue and fly ash in underground floor concrete, this study adopted fly ash to partially replace cement and coal gangue to partially replace natural aggregates and prepared concrete specimens with various curing ages to investigate their strength evolution rules and long-...

Wei-Li Li, Guang Yang, Feng-Hui Li et al. · 0 citations
Open access Sep 2026

Mechanical performance evaluation of conventional and pervious concrete reinforced with steel and nylon fibers

Performance enhancement of concrete to meet modern infrastructure demands has become essential in the construction industry. This study presents an experimental investigation of the incorporation of steel and nylon fibers in conventional and pervious concrete to evaluate their mechanical strength and permeability behav...

Md. Izharul Haque Azad, Mahmoud A. Helal, Magdalena Malek et al. · 0 citations
Open access Sep 2026

Assessment of the Impact of Oil-Contaminated Sand on the Structural Performance of Reinforced Concrete: Experimental and Numerical Analysis

This study presents a systematic investigation of the physical, chemical, microstructural, and mechanical properties of oil-contaminated sand (OCS) and the resulting concrete, alongside a structural evaluation of RC beams under monotonic loading. Sixteen groups of concrete cylinders were cast at oil contamination level...

Mustafa A. Saeed, Z. Itam, Meqdam Hatem Hammadi Alakashe et al. · 0 citations
Open access Aug 2026

MECHANICAL PERFORMANCE OF HYBRID FIBER-REINFORCED CONCRETE: THE SYNERGISTIC EFFECT OF RAMIE AND MICRO SYNTHETIC FIBERS

Conventional concrete has limitations in tensile strength and crack control. Fiber-reinforced concrete improves these properties, but single fiber types can hinder performance. While steel fibers are common, synthetic and natural fibers are gaining traction due to their cost-effectiveness, performance, and eco-friendli...

Delista Putri Deni, Aziz Abdul Majid, O. Kurnianingsih et al. · 0 citations
Open access Sep 2026

Study on Compression Fracture Evolution and Damage Mechanism of Coal–Rock Composite Specimen Under Different Coal Interlayer Thickness

This study investigates how coal interlayer thickness influences the compression fracture evolution and damage mechanism of coal–rock combinations. Pure coal, pure siltstone, and siltstone–coal–siltstone specimens with 2‐ and 3‐cm coal interlayers were examined through uniaxial compression tests combined with acous...

Rong Tang, Yang Xiao, Qiu Li et al. · 0 citations
2026

High Strength Concrete (M40) Using Micro Silica and Steel Fiber

This experimental study examines the combined effects of micro silica (silica fume, SF) as a partial cement replacement and hooked-end steel fibers on the mechanical properties of M40 grade concrete. Concrete mixes were designed as per IS:10262 with a target characteristic compressive strength of 40 MPa. Silica fume wa...

Shaikh Shoeb Sb · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.