Skip to content
Open access

Neural network-based prediction of actively controlled sweep events in a fully turbulent channel flow

Aug 2026 · The Physics of Fluids · Vol 38 · 0 citations · 55 references

TL;DR

This study investigates the use of a feed-forward neural network (FNN) and a hybrid approach combining an FNN with proper orthogonal decomposition (POD) to estimate the effect of control on sweep events within an opposition control framework and reveals a high sensitivity to the actuation frequency and delay time parameters, whereas a lower sensitivity was observed with respect to the voltage amplitude.

Abstract

This study investigates the use of a feed-forward neural network (FNN) and a hybrid approach combining an FNN with proper orthogonal decomposition (POD) to estimate the effect of control on sweep events within an opposition control framework. Conditionally averaged sweep events (CASEs) were experimentally sampled in a fully turbulent channel flow at a friction Reynolds number of 350. The two architectures were then trained to reconstruct the controlled CASEs using the control parameters (frequency, voltage amplitude, and delay time) as input. The results indicate that both approaches are able to reproduce the control signature across different actuation parameters with comparable accuracy. At the same time, the hybrid POD–FNN architecture requires over two orders of magnitude fewer trainable parameters. Finally, both local and global sensitivity analyses were performed, leveraging the differentiability of the trained models and their rapid inference times. The Jacobian matrix and Sobol indices were computed to conduct a local and a global sensitivity analysis, respectively. The findings revealed a high sensitivity to the actuation frequency and delay time parameters, whereas a lower sensitivity was observed with respect to the voltage amplitude.

Read PDF

Similar papers

Open access Sep 2026

Training artificial neural networks to control an active grid for shaping inflow profiles

In wind tunnel experiments, one approach to reproducing the representative flow environment around test bodies is the use of obstacles, which necessitates longer test sections. As an alternative, an active grid system, consisting of motor-driven rods with attached winglets, was introduced by Makita (1991 Fluid Dyn. Res...

Gokhan Keskin, F. O. Edis · 0 citations
Sep 2026

Turbulence modeling using physics-informed neural networks: The importance of training points distribution and hyper parameters

Physics-informed neural networks (PINNs) are employed to solve the Navier–Stokes equations with a standard k–ω turbulence model for flow over a period, focusing on how the spatial placement of training points and hyperparameters affect accuracy. Wall-bounded turbulence modeling includes challenges because variables lik...

Arash Divazi, M. Tahani · 0 citations
Conference Aug 2026

Neural Network Complexity Analysis for Data-Driven NARX Identification of a Pneumatic Levitation System

This paper addresses nonlinear system identification using neural networks within a nonlinear autoregressive model with exogenous input (NARX) framework. An unknown discrete-time dynamic system is modeled from 4000 normalized input–output samples acquired at a sampling time of 0.2 s. A systematic study is conducted to...

S. Bernal, Manuel Ortiz Camacho · 0 citations
Aug 2026

Investigation of Neural Network-Based Calibration of the Geko Turbulence Model for High-Lift Airfoil Flow Prediction

Accurate prediction of aerodynamic forces for high-lift configurations remains challenging in CFD due to turbulence modeling limitations. This study applies neural network-based calibration to the Generalized κ–ω (GEKO) model to improve flow prediction over a multi-element airfoil. Baseline SST-κ–ω and GEKO models matc...

Kaushik Chavali, Raghul Subramani, Shankar Kaira et al. · 0 citations
Open access Aug 2026

Prediction of Wing Pressure Distribution Using an Autoencoder-Based Surrogate Model

The key feature of the proposed model is its ability to predict the pressure distribution for trapezoidal wings of various geometries 101–104 times faster than numerical models, while maintaining accuracy (R2 = 0.9998).

O. Lukyanov, Damian Josue Guerra Guerra, J. G. Quijada Pioquinto et al. · 0 citations
Open access Aug 2026

Neural-Network-Assisted FCC Kinetic Modeling for Enhanced Parameter Estimation Using the CREC Riser Simulator

This study presents an integrated framework for developing kinetic models of vacuum gas oil (VGO) catalytic cracking under sparse experimental data conditions. Experiments were performed in the CREC Riser Simulator at different C/O (catalyst/VGO) weight ratios. The CREC Riser Simulator is a bench-scale mini-fluidized r...

Jansen Gabriel Acosta-López, Nicolas Torres Brauer, H. de Lasa · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.