Skip to content
Open access

STUDY OF CEMENTING COMPOSITIONS BASED ON HYDROCARBON OIL FOR REPAIR AND ISOLATION OPERATIONS

Sep 2026 · Petroleum Engineering · Vol 24, pp. 18-27 · 0 citations

Abstract

Repair and isolation operations remain among the most critical well interventions aimed at restoring casing integrity and limiting water inflows in oil and gas wells, and their efficiency is largely governed by the properties of the cementing slurries applied. Cement slurries mixed on a hydrocarbon dispersion medium do not hydrate and stay low-viscosity until they contact water, so they are suitable for treating water-sensitive and oil-saturated intervals. However, diesel fuel and crude oil, traditionally used as the base, have an unstable composition, elevated toxicity and a tendency to form resin–asphaltene films. The aim of this work is to assess the applicability of a highly refined synthetic hydrocarbon base as the dispersion medium of a hydrocarbon–cement slurry and to determine the effect of the nonionic surfactant concentration on the technological and strength characteristics of the slurry hardened with an aqueous sodium hydroxide solution. Flowability, density and sedimentation stability were measured in the laboratory by centrifugation; the forced displacement of the hydrocarbon base by the aqueous hardening fluid was reproduced, after which the compressive strength of the set cement was tested and the hydrocarbon wash-out efficiency was calculated. Adding the nonionic surfactant reduces the separated filtrate fraction from 20 to 2–4 % and provides high sedimentation stability already at additive contents of 0.29–0.65 %, while flowability stays within the workable range of 17–19 cm. The compressive strength depends non-monotonically on the additive concentration and reaches a maximum of 114.4 MPa, 2.5 times that of the additive-free control. The governing factor is not the completeness of hydrocarbon-phase displacement but the wetting of the cement grain surface by the aqueous phase: reduced interfacial tension and the adsorption layer formed ensure rapid hydrophilization of the grains upon contact with water, which accounts for the strength gain. Thus, the synthetic hydrocarbon base can be used in cementing compositions for repair and isolation operations.

Read PDF

Similar papers

Open access Sep 2026

STUDY OF GROUTING COMPOSITION FOR RESTORING THE TIGHTNESS OF THE PRODUCTION WELL CASING AND ELIMINATING WATER INFLUX

This article presents the results of a study of a composite fast-hardening cement slurry based on urea-formaldehyde synthetic resin, designed for effective waterproofing and repair and insulation work. Unlike similar products, this fast-hardening cement slurry effectively cures over a wide temperature range from 20°C t...

G. Dubinsky, V. Mukhametshin · 0 citations
Open access Sep 2026

Improving the quality of well cementing through the use of nanocomposites: field data analysis and evaluation of their effect on cement slurry properties

Background: The challenging geological and thermobaric conditions of the Western Kazakhstan oil fields impose stringent requirements on cement slurry systems, while standard Portland cement formulations frequently fail to provide adequate zonal isolation over the well’s production lifecycle. Aim: This study aims to id...

A. G. Khassenov, A. S. Mardanov, D. Р. Abdrakhmanov et al. · 0 citations
Conference Oct 2026

Research on the Properties of Cement Sheath for Heavy Oil Thermal Recovery

This study addresses the challenges associated with heavy oil extraction using steam stimulation. The injection of high-temperature steam severely tests the integrity of the cement sheath, leading to concerns such as alterations in cement hydration and strength degradation under elevated temperatures. Furthermore, th...

Rui Zheng, Hai-Long Li, Yong Li et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.