High-performance triboelectric nanogenerator based on aerosol jet printed hollow micro-ring arrays
Abstract
To address the challenges of complex fabrication processes and insufficient utilization of effective contact area and edge electric field in surface modification of flexible triboelectric nanogenerators (TENGs), this study employs high-resolution Aerosol Jet Printing (AJP) technology to precisely fabricate a staggered checkerboard-arranged hollow micro-ring array on a polyimide (PI) film, enabling the development of a Hollow Micro-ring Array-based Triboelectric Nanogenerator (HMR-TENG). The influence of printing layers (5-30 layers) on the electrical output characteristics of HMR-TENG is systematically investigated. The results demonstrate that under a contact-separation mode of 20 N and 10 Hz, the 20-layer configuration achieves the optimal synergistic state among structural height, effective contact area, and edge electric field enhancement, yielding a peak-to-peak open-circuit voltage of 318.6 V and a short-circuit current of 9.1 μA, representing a 3.34-fold improvement over the pristine planar PI-based device, At the optimal matching load resistance of 107Ω, the device delivers a maximum output power of ~0.72 mW, yielding a corresponding power density of 0.289 W/m².Application validation demonstrates that after full-bridge rectification, the device achieves a stable output voltage of 25 V with a pulse width of approximately 8 ms following continuous actuation for about 10 s, successfully triggering stable discharge ignition of a transducer element. This work provides new insights into enhancing TENG performance through edge electric field effects and offers a viable pathway toward the engineering application of miniaturized self-powered transient drive systems.