Skip to content

Similar papers

Open access Sep 2026

Effects of Cr Addition on Microstructure and Mechanical Properties of Heat-Resistant Al-Cu-Mg Alloys

Al-7Cu-0.3Mg alloys with different Cr contents were prepared by melting and casting. The microstructure and tensile mechanical properties of the as-cast and T6 heat-treated alloys were investigated at room temperature and 350 °C. The results show that Cr addition not only significantly refines the primary α-Al grains a...

Shun He, Yu Xiong, Ting-Ting Zhang et al. · 0 citations
Conference Sep 2026

Study on the microstructure and corrosion of Al-Zn-Mg-Cu alloy welded joint after heat treatment

The Al-Zn-Mg-Cu high-strength aluminum alloy is widely employed in lightweight load-bearing structures for aerospace and rail transit applications, owing to its exceptional specific strength and excellent processability. Bobbin Tool Friction Stir Welded (BT-FSW) effectively mitigates defects inherent to conventional fu...

Jie Tan, Mei Lin · 0 citations
Review Open access Sep 2026

Microstructure–Property Relationships in Heat-Treated A356 Aluminum Alloy: A Concise Review

Heat-treated A356 aluminum alloy has attracted sustained attention because of its low density, good castability and corrosion resistance. These properties make it valuable for automotive, structural and aerospace applications, while its final performance depends strongly on microstructural control. This review examines...

Philisile Kgothatso Sekgata, M. Mathabathe · 0 citations
Oct 2026

Study on the Microstructure, Wear, and Corrosion Resistance of W, Ni, and Co-Doped Fe-Alloys Processed by Solid-State Sintering

Iron-based alloys with compositions Fe3CWNi, Fe3C10WCo, and Fe3CWNiCo were synthesized by solid-state sintering at 1400 °C. This study investigates how additions of nickel (Ni), cobalt (Co), and tungsten (W) enhance the microstructure, wear resistance, and corrosion behavior of the prepared alloys. Microstructural char...

Lahcene Mebarki, L. Baroura, Kamel Fedaoui et al. · 0 citations
Open access Oct 2026

A Comparative Study on Microstructure and Mechanical Properties of Friction Stir Welded Butt Joints Produced Under Different Cooling Conditions in a High-Strength Al–Cu–Li Alloy and an Al–Zn–Cu–Mg Alloy Modified with Ag, Zr, and Sc

This study provides a comprehensive and novel comparative investigation into the evolution of microstructure and mechanical properties of FSW butt joints in a high-strength Al–Cu–Li alloy and an Al–Zn–Cu–Mg alloy modified with Ag, Zr, and Sc, processed under different cooling conditions (ambient air and forced water co...

S. Tarasov, E. Sidorov, D. Gurianov et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.