Oct 2026· International Journal of Engineering and Management Research· 0 citations· 5 references
Abstract
Portland cement production contributes roughly 7–8% of global CO₂ emissions, which has driven interest in supplementary cementitious materials and carbon-sequestering additives. This study evaluates coconut-shell-derived biochar, used as a cement-weight additive at 0–5%, in a fly ash blended concrete system. Biochar was characterized by EDX (carbon 77–80%, oxygen 15–16%) and physical tests (specific gravity 1.60, fineness modulus 1.83, water absorption 15.8%). Concrete specimens were tested for compressive, split tensile and flexural strength at 7, 14 and 28 days, and for strength loss after sulphate attack, chloride attack and alternate wet–dry cycles. A 1% biochar dose gave the highest 28-day compressive strength (33.8 MPa, +7.0% over the 31.6 MPa control), and 2% gave 33.2 MPa (+5.1%). Doses of 3% and above gave no gain or a reduction. Early-age (7- and 14-day) split tensile and flexural strength improved at 1–3%, but 28-day tensile and flexural strengths were below the control for all dosages. Durability was best at 2% biochar, where strength loss was 2.2% (sulphate), 1.8% (chloride) and 2.8% (wet–dry), against 8.5%, 7.0% and 9.0% for the control. The results indicate that a low biochar dosage of about 1–2% can improve compressive strength and durability, while higher dosages are detrimental.
The cement industry accounts for approximately 8% of globally anthropogenic CO₂ emissions and requires sustainable solutions. The use of the commercially available BBQ coal biochar for partial cement replacement for carbon sequestration in concrete was studied. Five different concrete mix proportions were designed usin...
Gul Zaman Lashari, Mahmood Laghari, Sheeraz Aleem Brohi et al.· Kashmir Journal of Academic...· 0 citations
The cement and concrete industry contributes approximately 8% of global CO2 emissions, creating a need for cementitious materials that can both reduce emissions and store carbon. This study demonstrates that biochar can be incorporated at unprecedented levels of up to 20% by mass of cement while maintaining or improvin...
Islam Orynbassarov, Temirlan Barissov, Seunghee Kim et al.· Infrastructures· 0 citations
Growing demand for sustainable construction materials has increased interest in industrial by-products as replacements for conventional aggregates. This study develops eco-friendly lightweight concrete (LWC) using cinder as a complete replacement for natural coarse aggregate, combined with nano-calcium carbonate (Nano-...
S. Bhavya, M. B. Ananthayya, K. S. Sreekeshava et al.· Construction Materials· 0 citations
Ordinary Portland cement (OPC) production contributes approximately 7–8% of global anthropogenic carbon dioxide emissions, motivating the development of low-carbon binders from agro-industrial waste. This study investigates the mechanical, physical, and microstructural properties of geopolymer mortar using palm oil fue...
H. Rahim, Salsabilla· Science Get Journal· 0 citations
Fly ash is a waste product from coal combustion and can be used as a partial substitute for cement, thereby aiding in the production of lower-carbon-footprint concrete. Most studies have focused only on mechanical or environmental performance, and fewer studies are available that integrate properties of fly ash concret...
B. A. S. Ovy, M. Bashar, Md. Al Imran Hossan· Journal of Applied Materials...· 0 citations