Skip to content

Mechanical recycling of CFRP Composites—Part I: Characterizing carbon fiber and cured epoxy as dispersed phases

Oct 2026 · Journal of composite materials · 0 citations · 41 references

Abstract

This study investigates carbon-fiber fabric and cured epoxy as separate fractions to establish a baseline for the mechanical valorization of carbon fiber-reinforced polymers (CFRP). Unrecycled components were used to isolate the effects of identity, geometry, processing, and reinforcement content without the variability of CFRP recyclates. Millimeter-scale fabric fragments and cured-epoxy chips from face and peripheral milling were added to an epoxy matrix at 1–5 wt%. High-energy ball milling (HEBM) was also used to produce CF–HEBM, EL–HEBM, and ES–HEBM, added at 3–10 wt%. Morphology and mechanical response were evaluated using optical microscopy, SEM–EDS, tensile, flexural, and Izod impact tests. No single fraction improved all properties. Short carbon fragments at 1–3 wt% yielded the highest mean Izod impact strength (∼33–34% above neat epoxy), though this difference was not significant after Holm–Bonferroni correction, and tensile strength was lowered. Epoxy-derived chips acted mainly as fillers, maintaining baseline tensile strength at 5 wt% without flexural or impact gains. HEBM had the strongest impact on carbon fibers: CF–HEBM-3 reached 42.22 MPa tensile strength (neat: 30.31 MPa), and CF–HEBM-10 reached 96.60 MPa flexural strength (neat: 64.58 MPa). Microstructural analysis showed that ball milling reduced fibers into particulate matter, whereas epoxy retained angular, plate-like fragments, with minor Fe and Cr contamination detected by SEM–EDS.

View source

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.