Skip to content
Open access

Steady RANS Assessment of Stall Fence Effects on Wells Turbine Performance for Oscillating Water Column Systems

Aug 2026 · Research in Education, Technology, and Multiculture · Vol 5, pp. 222-238 · 0 citations

Abstract

The Wells turbine is a key component in an Oscillating Water Column (OWC)-based ocean wave energy conversion system, yet its limited operating range due to leading-edge stall constrains overall system efficiency. This study presents an independent CFD benchmark of the performance of the Wells turbine with and without a passive flow control device, a stall fence, as investigated by Das and Samad (2020). Steady Reynolds-Averaged Navier-Stokes (RANS) simulations using the SST k-ω turbulence model were performed in ANSYS CFX v22.1 by replicating the original geometry, boundary conditions, and mesh density for direct comparison. The reference turbine (eight NACA 0015 blades, solidity 0.64) and the configuration with a stall fence (fences at 40% and 80% span) were evaluated over a flow coefficient range of φ = 0.075-0.275. Grid independence study using quantitative (non-dimensional torque T*) and qualitative (tip-vortex topology) criteria resulted in the selection of a 3.5-million-element mesh. For the reference turbine, a mean absolute percentage error (MAPE) of 2.0% for T* and 3.1% for efficiency was obtained in the pre-stall range (φ ≤ 0.225), confirming strong numerical reproducibility. However, steady RANS failed to predict the stall onset for the reference configurations and overpredicted torque by up to 508% in the post-stall region. The stall point at φ = 0.250 was successfully reproduced with a deviation approaching zero, proving that the vorticity induced by the fence geometry enhances the reliability of RANS stall predictions. The pre-stall MAPE for the fence configuration was 4.4% for T*, slightly higher due to local vortex interactions around the fence. These findings establish steady RANS as a reliable design tool in the pre-stall range and demonstrate that passive fence stalls not only extend the turbine’s operating range but also improve the accuracy of CFD predictions. Keywords: Wells turbine, Stall fence, CFD benchmark, Steady RANS, Ocean wave energy conversion.

Read PDF

Similar papers

Open access Sep 2026

CFD-Based Performance Assessment of Flanged Diffuser Configurations for a Horizontal-Axis Marine Current Turbine

Marine current turbines can provide predictable renewable power, but their performance at moderate current speeds depends strongly on the flow delivered to the rotor. This study numerically evaluates an open horizontal-axis marine current turbine and two flanged diffuser configurations with short and long expansion sec...

Najdan Waris C.P · 0 citations
Open access Sep 2026

Numerical Investigation of Impeller Leading-edge Profiling on Vortex Suppression and Performance Enhancement in a Pump-as-turbine

Centrifugal pumps operating as turbines (PAT) offer a cost-effective solution for micro-hydro power plants. However, their hydraulic performance is compromised by flow separation at the impeller’s outer diameter. This study conducted a transient numerical analysis to evaluate the hydrodynamic effects of modifying sharp...

Fadhlurrahman, Sutardi · 0 citations
Conference Open access 2026

Performance Estimation of Ducted and Bare Tidal Turbines using CFD

The main objective of this study was to investigate the effect of flow contraction created by a duct on the power generation of a tidal turbine prototype. As a preliminary step in the development of a full-scale floating bridge-type ducted turbine, aimed at shallow near-shore locations subject to tidal currents with mo...

Ali Edalat, Luis Martins, S. Teixeira et al. · 0 citations
Open access Sep 2026

Experimental–CFD Optimisation of Hydraulic Jet Reach for the GS Mark III Peatland Firefighting System

The use of Computational Fluid Dynamics (CFD) with surrogate-based optimisation is increasingly becoming common in the design of fluid delivery systems although there are very few cases where it has been applied to fixed water-based fire suppression systems. This paper seeks to propose an integrated four-stage engineer...

Wan Mohd Zaifurin Wan Nawang, Azfarizal Mukhtar, Mohd Zamri Yusoff et al. · 0 citations
Conference Open access Sep 2026

Large-eddy simulation of serration effects on a rotating Wells turbine in transient inflow

In recent years, global energy demand has continued to increase, and international competition over securing energy resources has begun to intensify. Under these circumstances, various research initiatives and demonstration projects have been launched to promote the adoption of renewable energy for stable energy supply...

Shinji Narukawa, Eru Kurihara, Yuki Ogimoto et al. · 0 citations
Open access Sep 2026

Validated CFD-Based Performance Characterization and Cavitation-Susceptibility Screening for Comparative Turbine Selection in Micro-Hydropower Systems

Turbine selection requires information on the operating range as well as peak efficiency. This paper extends previously documented bench-scale Francis, Pelton, and Cross-flow turbine data through a new analysis of CFD and laboratory performance curves. The original ANSYS CFX (2025) calculations used steady incompressib...

F. Kifumbi, G. Ngoma, F. Erchiqui et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.