Skip to content
Open access

Thermomechanical and experimental analysis of Fe3O4 and CaCO3 nanofluid cooling for photovoltaic panels under hot climate conditions

Oct 2026 · Advances in Mechanical Engineering · Vol 18 · 0 citations · 97 references

Abstract

Photovoltaic (PV) systems, particularly in hot climates. This study experimentally investigates nanofluid-based cooling as an effective strategy to enhance PV performance under real outdoor conditions. Two environmentally friendly nanofluids—ferromagnetite (Fe3O4) and calcium carbonate (CaCO3)—were examined at concentrations ranging from 0.5 to 1.3 wt.% and flow rates between 1000 and 7000 ml/min, with water cooling and a non-cooled PV panel used as reference cases. The results show that Fe3O4 at 1.3 wt.% and the highest flow rate achieved the best overall performance, yielding a temperature reduction of 36.3%, a power output increase of 27.6%, and an electrical efficiency enhancement of 27.8%. CaCO3 also demonstrated notable performance, achieving a 34.77% temperature reduction and approximately a 20.52% increase in power output, and a 27.84% increase in efficiency, while water cooling provided only moderate improvements. Increasing nanoparticle concentration and flow rate under turbulent conditions (1.3 wt.% and 7000 ml/min) significantly enhanced the performance of Fe3O4 nanofluid, which exhibited a peak Nusselt number of 110.23, substantially higher than those of CaCO3 (55.27) and water (15.32). In addition, the thermal performance factor increased, indicating improved overall heat transfer characteristics. The selection of Fe3O4 and CaCO3 is motivated by their chemical stability, non-toxicity, low cost, and availability, supporting both environmental and economic sustainability. Overall, the results confirm that nanofluid-based cooling significantly outperforms conventional cooling methods, offering a scalable and climate-resilient solution for enhancing PV system efficiency.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.