Skip to content
Open access

Engineered Fe2O3/TiO2/Carbon-Dots Heterostructures for Enhanced Photoelectrochemical Water Oxidation

Oct 2026 · ACS Applied Energy Materials · 0 citations · 48 references

Abstract

Hematite (α-Fe2O3) is an abundant, low-cost visible-light absorber and a leading photoanode candidate for solar-driven water splitting, yet its conversion efficiency remains constrained by poor charge transport, fast electron–hole recombination, and sluggish oxygen evolution reaction (OER) kinetics. Here, we engineer a Fe2O3/TiO2/Carbon-dot (C-dot) photoanode built on an FTO substrate that addresses these bottlenecks through a defined layer architecture: hydrothermally grown Fe2O3 nanorods provide visible-light absorption, a sol–gel-deposited mesoporous TiO2 overlayer passivates the hematite surface, and finally solvothermally grown C-dots decorate the outer surface to drive interfacial charge transfer. Structural and chemical characterization confirms a well-integrated, intimately contacted heterostructure, while optical measurements show that C-dot incorporation broadens visible-light harvesting without altering the underlying optical band gap (∼2.1 eV) indicating that any performance gain originates from charge-transport rather than band-structure effects. Under photoelectrochemical testing, the Fe2O3/TiO2/C-dots photoanode delivers substantially higher OER photocurrent than the Fe2O3/TiO2 baseline across the full UV-to-visible illumination range, with simulated-solar photocurrent density increasing by approximately 2.5-fold at neutral pH and by approximately 3.4-fold under alkaline conditions, pH 14, where OER kinetics are most favorable. The device sustains stable, reproducible photocurrent over multi-hour continuous solar illumination in both electrolytes, supporting its operational robustness under realistic water-splitting conditions. Mechanistically, Mott–Schottky analysis shows that C-dot incorporation more than doubles the carrier density (from 1.6 × 1020 to 3.3 × 1020 cm–3), while electrochemical impedance spectroscopy reveals a ∼27% reduction in interfacial charge-transfer resistance, together identifying enhanced carrier density and accelerated interfacial charge transfer, rather than band-edge modification, as the origin of the improved device performance. These results establish C-dot functionalization as a simple, scalable strategy for boosting the photocurrent and operational stability of Fe2O3/TiO2 photoanodes, with direct relevance to the design of higher-performing, low-cost solar-to-fuel conversion devices for water oxidation and solar hydrogen production.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.