Skip to content
Conference Open access

TiO₂ Nanoparticles in Low-Salinity Waterflooding: An Experimental Study on Wettability Alteration and Oil Recovery

Oct 2026 · RSF Conference Series Engineering and Technology · 0 citations · 21 references

Abstract

Low-salinity waterflooding combined with titanium dioxide (TiO₂) nanoparticles can improve microscopic oil displacement by modifying oil–brine and rock–fluid interactions. This study presents a preliminary experimental evaluation of TiO₂-assisted low-salinity waterflooding using Berea sandstone and crude oil from a mature oil field in Indonesia. Synthetic NaCl brines with salinities of 500–32,000 ppm were prepared, while TiO₂ concentrations of 100, 250, and 500 ppm were evaluated. Interfacial tension (IFT) was measured using a spinning-drop tensiometer, wettability was assessed through contact-angle measurements, and selected formulations were subsequently evaluated by coreflooding at 68°C. The measured IFT values ranged approximately from 1.4 to 7.5 mN/m, with 100 ppm TiO₂ producing the lowest IFT under most tested salinity conditions. Contact-angle measurements also shifted toward more water-wet conditions, with the largest decrease from approximately 29.5° to 14.5° after adding 100 ppm TiO₂. Coreflooding at 8,000 ppm brine showed that 100 ppm TiO₂ increased the recovery factor from 9.26% to 30.42% ROIP, corresponding to an incremental recovery of 21.16 percentage points. These preliminary results identify 100 ppm TiO₂ as the most favorable tested concentration. Nevertheless, the optimum formulation remains specific to the investigated rock–brine–oil system because nanoparticle stability, retention, and surface charge were not independently measured.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.