Geomechanical Stability Assessment and Risk Prediction of Faults and Caprocks During Long-Term CO2 Injection
Abstract
To elucidate the coupled relationships among pore-pressure recovery, expansion of the miscible zone, and reservoir stress redistribution during CO2 flooding, and to provide a basis for optimizing gas-injection intensity and managing geomechanical risk, this study investigates the Block 8-530 CO2-EOR pilot test area. Geological, well-log, rock-mechanics, three-dimensional (3D) geological-modeling, compositional-simulation, and injection-production performance data were integrated to establish a workflow of "static geomechanical characterization–pressure-scenario constraint–dynamic stress response–stability assessment–operational optimization." The pilot initially adopted a pattern of nine injectors and 28 producers and was subsequently expanded to 15 CO2 injectors and 41 producers. Based on the effective-stress principle, the Mohr–Coulomb criterion, tensile-fracture conditions, and dynamic capillary-sealing concepts, the injection process was divided into three scenarios: immiscible pressure recovery, stable miscible operation, and conditional pressure increase, allowing the coupled effects of pressure evolution, stress redistribution, fracture stability, and CO2 sweep behavior to be systematically evaluated. Following CO2 injection, the average reservoir pressure recovered from 17.8 to 24.8 MPa, while the central area reached 25.5 MPa, exceeding the minimum miscibility pressure (MMP) of 24.1 MPa and enabling some well groups to enter the miscible-displacement stage. The present-day maximum horizontal principal stress trends northeast–southwest at approximately 45°, and the stress regime is characterized by normal faulting (Shmin < SHmax < Sv). The 3D geomechanical model reveals pronounced spatial heterogeneity in reservoir elastic properties and horizontal stresses, with the S74 interval exhibiting relatively low horizontal stress and a small horizontal-stress contrast, making it a key interval for preferential CO2 sweep and fracture response. The results further indicate that increasing reservoir pressure can markedly reduce effective stress and improve pore and fracture conductivity; however, rapid localized pressurization may amplify interwell pressure gradients and stress heterogeneity, thereby increasing the susceptibility of pre-existing hydraulic fractures, interlayer weak planes, and high-permeability pathways to shear slip and opening. Available field data support 24.1–25.5 MPa as the currently validated miscible operating window. Pressure-increase schemes above the present central-area pressure should therefore be implemented in small increments, in stages, and with stabilization holds, together with closed-loop calibration using bottom-hole pressure, tracers, produced-gas composition, casing deformation, and microseismic monitoring. The proposed workflow integrates compositional flow simulation with dynamic geomechanical assessment and provides a practical framework for balancing miscibility enhancement, injection-performance optimization, and geomechanical-risk control during CO2-EOR development.