Skip to content
Conference Open access

Effects of the slag skin physical properties on the heat and mass transfer during initial solidification in continuous casting process

Oct 2026 · Journal of Physics, Conference Series · Vol 3342 · 0 citations · 16 references
Physics

Abstract

Initial shell formation in continuous casting is governed by coupled flow, heat transfer and mould-flux infiltration near the meniscus. In this work, an in-house two-phase OpenFOAM-based model with geometric VOF interface tracking is applied to study liquid-steel flow and solidification, slag infiltration and re-solidification including surface tension effects. Three slag skin parameters were varied: (i) break temperature, (ii) viscosity power-law exponent, (iii) steel–slag interfacial tension. These parameters mimic composition- and basicity-dependent changes in slag rheology and structure. The results show that break temperature and interfacial tension have the strongest influence on slag skin development. Lower break temperature promotes thicker slag skin, stronger slag feeding, lower local heat flux, and deeper ripple-type defects, whereas higher break temperature has the opposite effect. Lower interfacial tension destabilizes slag skin development and produces stronger heat-flux variations and a more irregular surface profile, while higher interfacial tension reduces slag feeding, increases mould-side heat flux, and leads to shallower, more regular defects. The viscosity exponent has a weaker effect on the global flow and temperature fields, but controls the sharpness of slag re-solidification and the resulting surface profile.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.