Evaporation-Regulated Direct Ink Writing of Porous Composite Separators for High-Performance Lithium-Ion Batteries
Abstract
Commercial polyolefin separators exhibit limited electrolyte wettability and thermal dimensional stability, while conventional fabrication methods provide limited control over pore structure. Herein, direct ink writing (DIW) was coupled with evaporation-induced phase separation to fabricate porous PVDF-HFP/Al2O3 composite separators for liquid-electrolyte lithium-ion batteries. The shear-thinning, predominantly elastic ink enabled stable extrusion and shape retention. Compared with doctor-bladed DB-PA prepared using the same composition and drying conditions, DIW promoted an interconnected sponge-like pore network through multidirectional DMF evaporation and limited ingress of atmospheric moisture. Printing speed governed separator morphology and electrochemical performance. The optimized PA-8 separator, printed at 8 mm s-1, achieved a porosity of 65.37%, electrolyte uptake of 203.94%, ionic conductivity of 1.38 mS cm⁻¹, and lithium-ion transference number of 0.82. It retained 62.33% of its original area after treatment at 180 °C. LiFePO4||Li cells using PA-8 delivered 120.52 mAh g-1 at 5 C and retained 95.41% capacity after 200 cycles at 1 C, outperforming Celgard 2500 (106.60 mAh g-1 and 87.63%, respectively). These results demonstrate that DIW-assisted phase separation enables controllable porous separators with improved electrolyte affinity, ion transport, thermal stability, and cell performance.