Skip to content
Conference Open access

Electrochemical Water Treatment: Conductive Materials and Energy Utilization Based on Ti4O7 Anode Electrooxidation Flocculation System

Oct 2026 · Journal of Physics, Conference Series · Vol 3331 · 0 citations · 15 references
Physics

Abstract

To address the issue of coexistence of suspended particles and natural organic matter in rural micro-polluted water sources, this study constructed an electro-oxidation flocculation coupling system. The system utilized Magnéli-phase titanium oxide (Ti4O7), stainless steel (SS), and carbon (C) as anode materials, and aluminum (Al) as the counter electrode. Using kaolinite-humic acid composite simulated water samples, the experimental results indicated that the optimal working voltage for the three systems was 7 V, and the optimal electrode spacing was 1 cm. The Ti4O7-Al system achieved a 82.70% humic acid removal rate and a 48.18% turbidity removal rate within 120 minutes, which was higher than the C-Al system, and showed a stronger simultaneous removal trend than the SS-Al system. Therefore, the calculated value of 6.13 Wh L−1 for the Ti4O7-Al system was used as an approximate indicator for relative comparison. The results indicated that the Ti4O7 anode could enhance the coupling between interface oxidation and hydroxide aluminum flocculation, but the medium turbidity removal level and the lack of long-term cycling data suggested that further verification of post-treatment devices, continuous current collection, and electrode aging characterization was still needed before engineering application. This study provided experimental basis for material selection and energy utilization analysis of decentralized water treatment low-voltage electrochemical water purification devices.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.