How Does Oil Composition Govern CO2-Nanobubble Interfacial Action?
Abstract
This paper examines how aqueous CO2 nanobubble solutions interact with oils of varying composition, using asphaltene content as the controlled compositional variable. The interfacial tension and surface viscoelasticity of a model oil (asphaltenes in 80:20 toluene/heptane at 0, 0.2, 1, 2, 10, and 20 g/L) are measured against nanobubble brine to quantify how oil chemistry governs the nanobubble effect on oil-water interfacial properties. Pendant-drop tensiometry (Krüss DSA30) provided dynamic and equilibrium interfacial tension, adsorption kinetics, and small-amplitude dilatational rheology (1–9% area strain, 1–1.5 Hz) across 176 runs spanning six asphaltene concentrations and three 5 wt% KCl aqueous phases: plain brine, CO2-nanobubble brine, and a CO2-sparged control carrying dissolved gas at matched pH, which separates bubble-specific effects from ordinary carbonation. All runs passed through uniform quality control, including a per-run correction of a sign ambiguity in instrument-fitted dilatational moduli, with replicates averaged and every exclusion documented. The nanobubble effect is strongly composition-dependent. Asphaltene alone reduces the interfacial tension (IFT) from 36 to ~30 mN/m by 0.2 g/L and to a flat 28–29 mN/m band at 2–20 g/L. Against this background, nanobubble brine lowers IFT by 16–20% at 2 g/L and above but only ~6% in asphaltene-lean oils, where the 0 and 0.2 g/L runs were still relaxing at 3000 s: the bubbles are most effective where the interfacial film is most developed. In plain brine the storage modulus climbs from 11 to 38 mN/m with concentration as a rigid asphaltene layer consolidates; in nanobubble brine it stays at 13–23 mN/m at every concentration — the stiff layer never forms. The sparged control shows carbonation contributes only ~1 mN/m and leaves film stiffness unchanged, and day-old nanobubble brine retains its full effect even after partial outgassing. This is a systematic map of nanobubble interfacial properties across oil composition, obtained with a dissolved-gas control that prior nanobubble studies lack. For the practicing engineer it offers a screening rule — nanobubble flooding could be best directed at asphaltenic crudes.