A joint transceiver beamforming and GIM design that maximizes a weighted combination of normalized worst-case communication and sensing distances is proposed, and an alternating optimization algorithm jointly refines the transceiver beamformers and GIM configuration.
Abstract
The combination of ultra-wide bandwidth and large-scale multiple-input multiple-output arrays with frequency-independent phase shifters induces beam squint, causing frequency and distance dependent array gain variations across subcarriers and degrading integrated sensing and communications performance. Transceiver beamforming and group index modulation (GIM) can alleviate the impact of beam squint on communication and sensing performance. However, their designs are coupled in the frequency domain, as beamforming shapes the subcarrier responses on which GIM grouping and activation depend. To address this coupling, we propose a joint transceiver beamforming and GIM design that maximizes a weighted combination of normalized worst-case communication and sensing distances. An alternating optimization algorithm jointly refines the transceiver beamformers and GIM configuration. Simulation results show that the proposed joint design reduces bit error rate in the high signal-to-noise ratio region and achieves a more favorable communication-sensing trade-off, while maintaining an average sensing AUC comparable to that of the considered GIM based benchmark schemes.
Next-generation wireless communications must be capable of meeting large capacity demands while simultaneously enabling highly accurate sensing. Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) is a pivotal enabler for integrated sensing and communication (ISAC) systems, owing to its large availab...
Ming-Ming Duan, Shun Zhang, Yao Ge et al.· IEEE Transactions on Wireles...· 0 citations
Integrated sensing and communications (ISAC) has significantly improved resource efficiency through spectrum and hardware sharing, and has become a key enabling technology for the next generation of wireless networks. Meanwhile, the deployment of extremely large-scale antenna arrays (ELAAs) and high carrier frequencies...
The beam squint effect has traditionally been viewed as detrimental to near-field wideband beamforming due to the reduction of beamforming gain towards the desired direction. In this paper, we show that it can instead be harnessed as a benefit in a hardware-constrained orthogonal frequency division multiple access (OFD...
Affine frequency division multiplexing (AFDM) has emerged as a competitive waveform for integrated sensing and communication (ISAC) in high-mobility scenarios, but its data-dependent high peak-to-average power ratio (PAPR) and ambiguity function (AF) sidelobes may degrade the power-amplifier efficiency as well as the s...
Shi-Qi Cui, Ze-Ping Sui, Tian-Qi Mao et al.· 0 citations
This paper proposes sensing-assisted OFDM with index modulation (SA-OFDM-IM) for joint communication and localisation over optical wireless systems. In SA-OFDM-IM, a multilayer frequency-domain architecture partitions each layer's admissible subcarriers into disjoint communication and distributed sensing-pilot subsets,...
A. W. Azim, M. S. Islim, M. Imran et al.· 0 citations
Hybrid beamforming is an essential technique to overcome the high path-loss of millimeter wave (mmWave) communications and allows a design trade-off between complexity and performance of fully digital and analog beamforming. However, the conventional implementation method of using phase shifters for the analog beamform...
Yu-Cheng Huang, M. el-Hajjar, Lie-Liang Yang· IEEE Access· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.