Hand-launched unmanned aerial vehicles require adequate low-speed lift and cruise efficiency. This study investigates a 3 kg propeller-aided biplane (PAB) with distributed electric propulsion using unsteady computational fluid dynamics. Propeller–wing arrangements are examined, followed by complete-aircraft simulations with transition modeling and sliding meshes. A conventional tractor configuration (CONV) provides a reference under comparable design constraints. Among the arrangements examined, over-the-wing and leading-edge tractor installations provide substantial lift augmentation. Predicted airframe loads are sensitive to transition modeling and the representation of propeller rotation. Although PAB has a lower clean-airframe lift-to-drag ratio, its smaller propeller-induced airframe drag penalty largely offsets this disadvantage at sampled fixed-rpm cruise conditions. At the 5 m/s hand-launch condition and angles of attack of 8–12°, PAB provides greater lift per unit shaft power with a comparable positive net forward force. At 12°, the lift-per-power gain is approximately 4%. About the respective design reference centers of gravity, cycle-mean nose-down moment magnitudes are approximately 77% and 49% smaller for PAB than for CONV at 8° and 12°. These predictions indicate hand-launch benefits for this non-optimized configuration pair under the prescribed conditions.
Aerodynamic interference between multiple propulsion systems can strongly affect the performance of unconventional Unmanned Aerial Vehicles (UAVs). This study investigates the interaction between a front tractor propeller, an upper lifting rotor, and the airframe of a dual-propulsion gyrodyne UAV using unsteady Reynold...
M. Mancino, Leonardo Guardenti, M. Rosellini et al.· Applied Sciences· 0 citations
Multi-rotor UAVs suffer from a sharp decline in rotor efficiency during high-speed cruise, severely limiting their endurance. To address this issue, this paper proposes a vertical takeoff and landing configuration that integrates a lift wing with an independent tail-mounted pusher. The wing lift unloads the vertical ro...
Lin Wei, Gui-Chao Cai, Ying-Qian Zhang et al.· Drones· 0 citations
Distributed electric propulsion (DEP) has gained significant attention for its potential to enhance aerodynamic and propulsive performance by leveraging the interaction between several propellers and the aircraft wing. To identify suitable DEP configurations and operating conditions, a wind tunnel investigation was con...
Eric Sadoway, S. Ghaemi· Journal of Aircraft· 0 citations
Hybrid Vertical Take-Off and Landing (VTOL) unmanned aerial vehicles (UAVs) combine the hovering capability of multirotor platforms with the efficient forward-flight performance of fixed-wing aircraft. However, achieving high aerodynamic efficiency during cruise flight remains a significant challenge because the wing o...
Hong Quan Pham· Journal of Science and Techn...· 0 citations
A tail-sitter vertical take-off and landing unmanned aerial vehicle (UAV) for low-altitude interception requires vertical launch capability together with efficient fixed-wing cruise. This study assesses the cruise aerodynamic feasibility of a 30 kg strake-wing concept using three-dimensional steady Reynolds-averaged Na...
Jing-Ming Xiao, Zhi-Yu Wu, Hong-Wei He et al.· Journal of Physics, Conferen...· 0 citations
This paper presents a high-speed wind tunnel investigation of compound helicopter aeromechanics, focusing on the effects of various lift and thrust compounding strategies. Six rotorcraft configurations, incorporating various combinations of wings and a pusher propeller, were tested at advance ratios up to 0.7. The comp...
Vivek Uppoor, Inderjit Chopra· Journal of Aircraft· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.