Skip to content
Open access

Integrated Vibration Suppression for Industrial Manipulators via Disturbance Observer and Partial Eigenstructure Assignment

Sep 2026 · Electronics · 0 citations · 28 references

Abstract

Residual vibration of industrial manipulators can limit positioning efficiency and dynamic accuracy during high-speed motion. This study develops an integrated vibration-suppression framework for a rigid-link manipulator with flexible-joint dynamics. A controller-oriented rigid–flexible model with lumped disturbances is established, and a disturbance observer (DOB) is employed as the inner-loop compensation layer under a small-gain robustness constraint. On the compensated nominal model, partial eigenstructure assignment (PESA) selectively increases the damping of the retained flexible modes while preserving the rigid-body eigenstructure associated with trajectory tracking. A pose-dependent gain-scheduling mechanism further updates the PESA feedback gain to accommodate configuration-dependent modal-frequency variation. Numerical comparisons with conventional PID, standalone DOB, and standalone PESA demonstrate improved residual-vibration attenuation and settling behavior. Hardware tests on an Aubo i5 manipulator, with 16-channel responses directly acquired under the respective control configurations, further show an approximately 80% reduction in the representative low-frequency vibration amplitude relative to the PID baseline under the considered operating condition.

Read PDF

Similar papers

Open access Sep 2026

Observer-Based Prescribed-Performance Tracking and Vibration Suppression of a Fractional Viscoelastic Flexible Manipulator

Flexible manipulators combine low moving inertia with pronounced elastic vibration, and commonly used controllers often assume integer-order damping, direct velocity/full-state information, or plant-specific tuning without an explicit transient-error guarantee. This work considers a single-link manipulator with heredit...

Lai-Xin Gao, Chao Lu, Ling-Chun Li et al. · 0 citations
Open access Sep 2026

Adaptive Boundary Vibration Control with Fault Tolerance and Asymmetric Input–Output Constraints of a Flexible Robotic Manipulator System

Flexible robotic manipulators are typical distributed parameter systems, and the resulting vibration deformation may affect their operation accuracy. This paper investigates the vibration attenuation and angular tracking control of a flexible robotic manipulator system subject to time-varying actuator faults, external...

Yong Zeng, Fang Guo, Yan-Fang Mei · 0 citations
Open access 2026

Modified Synchronization Sliding Mode Control of a 6-DOF Closed-Kinematic Chain Mechanism Robot Manipulator

This study addresses the motion control of a Closed-Kinematic Chain Mechanism (CKCM) robot manipulator possessing six degrees of freedom (DOF). A major challenge in controlling CKCM manipulators arises from errors in joint coordination, particularly during high accelerations or sudden changes in payload. These errors c...

T. T. C. Duong, Charles C. Nguyen, D. Tran · 0 citations
Open access Sep 2026

Comparative Analysis of Advanced Control Strategies for Vibration Control of Flexible Satellite Structures

Flexible satellite structures with lightweight solar panels are naturally prone to structural vibrations caused by attitude maneuvers, continuous environmental disturbances and deformation during deployment. These vibrations can lead to a decrease in pointing accuracy, a degradation in payload performance, and an adver...

Aslı Durmuşoğlu · 0 citations
Open access Sep 2026

Neural Network-Based Fixed-Time Control for Flexible Two-link Manipulators with State Constraints and Input Deadzone

Experimental results demonstrate that the proposed Fixed-Time control scheme reduces the steady-state tracking errors and vibration suppression, and fully validate the superiority and robustness of the proposed control strategy in balancing rapid convergence with vibration suppression.

He-Jia Gao, Tan-Yu Chen, Jiang-Xu Liu et al. · 0 citations
Open access Oct 2026

Output-Based Model Reference Adaptive Control of Satellite Manipulator

The limited availability of energy resources in space implementations requires the use of low-power and low-capacity actuators in satellite manipulators. This constraint makes it necessary to employ the manipulator structure to be lightweight in order to maintain task performance; however, the resulting increase in str...

Saliha Köprücü, İbrahim Mızrak, H. H. Bilgic · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.