Skip to content
Open access

Arch-Shaped Triboelectric Nanogenerator Based on PTFE, Paper, and Aluminum for Sustainable Energy Harvesting

Sep 2026 · Micromachines · Vol 17, pp. 1044 · 0 citations · 63 references
Medicine

Abstract

The growing adoption of flexible and portable electronic devices has created an increasing need for sustainable power sources that can operate without relying on conventional batteries. Triboelectric nanogenerators (TENGs) have attracted significant attention due to their ability to convert ambient mechanical energy into electrical energy. However, practical contact–separation TENGs may require additional spacers, elastic supports, or other structural components to maintain repeated contact and separation. This study presents a spacer-free arch-shaped TENG based on a laminated structure consisting of polytetrafluoroethylene (PTFE), paper, and aluminum. The arch configuration provides an inherent restoring tendency that facilitates contact–separation operation without a discrete spacer or additional elastic support. The fabricated device was experimentally evaluated through open-circuit voltage, short-circuit current, load-dependent electrical characterization, power measurement, capacitor charging, and LED illumination. Under the manual mechanical actuation conditions used in the present study, the device exhibited a maximum open-circuit voltage of 69 V, a reported peak short-circuit current of 68 μA, and a peak power output of 8.576 μW at an optimal load resistance of approximately 55 MΩ. Furthermore, the TENG charged a 4.7 µF capacitor to 7 V within approximately 60 s and directly illuminated 30 commercial light-emitting diodes (LEDs). These results demonstrate the feasibility of combining a simple spacer-free arch-shaped configuration with readily available materials for low-cost triboelectric energy harvesting. Long-term cyclic durability, controlled mechanical excitation, environmental stability, and matched structural control experiments remain important areas for future investigation.

Read PDF

Similar papers

Open access Sep 2026

Development of the microstructured polydimethylsiloxane for triboelectric generator to harvest mechanical energy

Finding a new clean energy power is a meaningful solution for the energy paucity and environmental protection. This paper introduces the microstructured PDMS surface (Mi-PDMS) for triboelectric nanogenerator (TENG) to harvest mechanical energy into electrical energy. The micro/nano structured surfaces have ability of e...

V. Trinh, Xuan-Chung Nguyen, Tien-Sy Nguyen et al. · 0 citations
Sep 2026

Multiscale-Engineered Porous Triboelectric Nanogenerator for Durable Energy Harvesting and Self-Powered Motion Recognition.

Wearable triboelectric nanogenerators require not only high electrical output but also mechanical compliance, elastic recovery, and long-term operational stability. Here, we report a multiscale-engineered porous triboelectric nanogenerator based on sugar-templated PDMS integrated with ZnO nanorods and MWCNTs. The optim...

Shu-Shuai Zhu, M. Shoeb, Fouzia Mashkoor et al. · 0 citations
Open access Oct 2026

Chitosan film based piezoelectric nanogenerator for ambient energy harvesting

Herein, we report a flexible chitosan-based piezoelectric nanogenerator (CPENG) fabricated using a simple and scalable solution-casting method from commercially available chitosan, an abundant and environmentally friendly biopolymer. The CPENG efficiently converts low-frequency mechanical stimuli into electrical energy...

Nirmal Baugh, S. Banerjee, P. Biswas et al. · 0 citations
Open access Oct 2026

High-performance triboelectric nanogenerator based on aerosol jet printed hollow micro-ring arrays

To address the challenges of complex fabrication processes and insufficient utilization of effective contact area and edge electric field in surface modification of flexible triboelectric nanogenerators (TENGs), this study employs high-resolution Aerosol Jet Printing (AJP) technology to precisely fabricate a staggere...

Yi-Fei Liu, Yong-Ping Hao, Hui Zhang et al. · 0 citations
Sep 2026

Bioinspired Cicada Wing Triboelectric Nanogenerator for Human Motion Monitoring and Mechanical Energy Harvesting.

The rapid development of portable electronic devices has created an increasingly urgent demand for flexible and portable power sources. The triboelectric nanogenerator (TENG) represents a promising technology for micro-energy harvesting, capable of efficiently converting mechanical energy from the environment into elec...

Jing-Fu Yuan, Du Guo, Zi-Jun Ning et al. · 0 citations
Open access Oct 2026

Triboelectric Nanogenerator-Based Stretch Sensor

Triboelectric nanogenerators (TENGs) have been extensively investigated as both energy harvesters and self-powered sensors. While their application as force sensors has been widely reported, the use of TENGs as stretch sensors remains relatively unexplored. Stretch sensors are important for monitoring human joint and l...

Ya-Fei Wang, Lei Shi, Miao-Miao Zhong et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.