Hybrid lightweight structures increasingly combine cast, wrought, and additively manufactured aluminum alloys, but the mechanical response of their welded joints remains strongly material-dependent. In this study, cast EN AC-42100-T6, wrought EN AW-6082-T6, and laser powder bed fusion (LPBF) AlSi10Mg stress-relieved plates were welded in 4 and 8 mm configurations using cold metal transfer and pulsed multi-control processes over two campaigns. Weld defects, microstructure, hardness profiles, and tensile properties were analyzed using a framework combining a hardness derived local yield-stress descriptor (σy,loc), a cumulative hardness deficit (IDHV), and a porosity increment metric (ΔP). The second campaign eliminated fusion and penetration related defects, but did not mitigate fusion zone porosity in LPBF-related joints, which reached 13.7% in the 8 mm LPBF–Cast joint. Hardness analysis showed the widest hardness-affected region in the wrought alloy, an intermediate response in the cast alloy, and localized alteration in LPBF. Tensile results identified three degradation modes: strength loss associated with heat-affected zone (HAZ) softening in wrought-containing joints, ductility limitation associated with the initial cast condition, and porosity-associated ductility loss in LPBF-related joints. The lower yield strength reduction in LPBF-related joints does not imply improved performance, as fracture remains strongly influenced by fusion zone porosity. The results support material specific mitigation and design strategies for hybrid welded aluminum structures.
Dissimilar aluminium alloys are widely used in automotive and aerospace structures because they are lightweight and strong. However, joining these alloys by fusion welding remains challenging because their different chemical compositions and thermal behaviour strongly affect weld quality. This study investigates how jo...
Okoubulu Augustine B., Ajao Akeem M., Nwaeju-Okechukwu Cynthia C. et al.· European Journal of Material...· 0 citations
Multi-pass welded joints of 10CrNi3MoV high-strength low-alloy (HSLA) steel were systematically investigated for high-cycle fatigue (HCF) behavior using microstructural characterization, mechanical behavior, and inherent defect analysis. Gas metal arc welding (GMAW; G1 and G2) and submerged arc welding (SAW; S1 and S2)...
Z.-W. Niu, Yu-Jia Yang, Yang-Wei Wang et al.· Metals· 0 citations
4Cr13 martensitic stainless steel is widely used for plastic molds, but welding repair can produce heterogeneous weld/HAZ microstructures and a strength–toughness trade-off. This study evaluates how filler-wire composition and post-weld heat treatment affect the mechanical performance of repaired 4Cr13 steel. TIG weldi...
Zhi-Yang Dou, Yatong Lyu, Hang Li et al.· Metals· 0 citations
Maraging steel, 4340 steel, and their dissimilar combination have similar applications in aerospace, defence, automobile and so on. This study examines and confirms the joint feasibility of their laser welding using mechanical testing, microstructural analysis, and texture analysis, thereby resulting in a sound dissi...
The increasing use of multi-material automotive structures has intensified the demand for reliable joining technologies capable of integrating lightweight aluminum alloys with ultra-high-strength steels. This study investigated the formation mechanisms, geometrical characteristics, mechanical performance, and interfaci...
P. Nascimento, R. Padovezzi, R. Amorese et al.· Journal of Manufacturing and...· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.