Skip to content
Open access

Asymmetric Flow-Electrode Capacitive Deionization for Copper-Containing Electroplating Wastewater Treatment Using Modified Sugarcane Bagasse Biochar

Oct 2026 · Water · Vol 18, pp. 2641 · 0 citations · 83 references

Abstract

Copper-containing electroplating wastewater is strongly acidic and highly saline, making efficient treatment challenging. Oxalic-acid-modified sugarcane bagasse biochar was prepared as an anode-side flow electrode for asymmetric flow-electrode capacitive deionization (AFCDI). Sugarcane bagasse biochar modified with 1.25 M oxalic acid (1.25OA-SC) was selected for its favorable overall balance of structural, electrochemical, and treatment characteristics. At 2.8 V, AFCDI achieved 98.12 ± 0.36% Cu2+ removal and lowered conductivity from 22.6 to 2.35 ± 0.66 mS/cm. This performance was associated with the combined effects of accessible porosity, oxygen-containing surface functionality, and electrochemical transport properties. Compared with conventional FCDI, AFCDI facilitated Cu2+ migration and cathodic deposit formation while achieving higher charge efficiency and lower electrical energy consumption. At 62.5 mL/g, Cu2+ removal remained above 98%, with an average TDS removal rate of 298.91 ± 7.19 g/(m2·h). During 10 consecutive AFCDI cycles using recovered 1.25OA-SC, Cu2+ removal remained above 98% and SO42− removal close to 80%, indicating short-term system-level performance retention. Cathodic deposits consisted mainly of Cu0 and Cu2O, whereas SO42− migrated through the anion-exchange membrane and was stored mainly by electric-double-layer charge compensation. These results demonstrate a biochar-based AFCDI strategy for coupled copper removal, recovery, and desalination of acidic sulfate-rich wastewater.

Read PDF

Similar papers

Redox-Capacitive Coupled Electrosorption for Selective Copper Recovery from Industrial Wastewater Using GO/MIL-88A/AC Electrodes

Selective removal and recovery of Cu2+ ions from industrial effluent was accomplished by a new redox-accelerated capacitive deionization (CDI) electrode with a hierarchical graphene oxide/MIL-88A/activated carbon composite (GO/MIL-88A/AC). The optimal electrode (E4, 6 wt %) exhibits a well-balanced charge storage mec...

Satish Kumar, P. Duarah, M. Purkait · 0 citations
Oct 2026

Strong electrochemical electrodes for strong environmental policies. On-site monitoring of heavy metals by means of engineered biochar materials.

Biochars derived from sunflower hulls and rice husks were chemically activated with chitosan/NaOH and investigated as electrochemical interfaces for trace-metal determination. The treatment improved electrode wettability, charge-transfer properties, and electrochemically accessible surface area, while favouring the in...

M. Mosquera-Ortega, V. Špada, J. Bilić et al. · 0 citations
Open access Oct 2026

Modified γ-Al2O3 Particle Electrodes Promote Active Chlorine Generation for the Treatment of Hypersaline Organic Wastewater

Electrochemical conversion of chloride to active chlorine is promising for treating chloride-rich organic wastewater, but enhanced oxidant production does not necessarily improve electrical efficiency. Here, Ti–Sn–Sb@γ-Al2O3 particle electrodes were prepared and applied in a flow-through three-dimensional electrocataly...

Lan Cheng, Tian-Wen Zhang, YX Fang · 0 citations
Conference Open access Oct 2026

Electrochemical Water Treatment: Conductive Materials and Energy Utilization Based on Ti4O7 Anode Electrooxidation Flocculation System

To address the issue of coexistence of suspended particles and natural organic matter in rural micro-polluted water sources, this study constructed an electro-oxidation flocculation coupling system. The system utilized Magnéli-phase titanium oxide (Ti4O7), stainless steel (SS), and carbon (C) as anode materials, and al...

En-Jie Ye, Hong-Rong Zhang, Qian Liu et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.