Epoxy spacers in gas-insulated substations (GIS) and transmission lines (GITL) accumulate surface charge under HVDC stress, distorting the electric field and lowering flashover voltage. Here, γ-rich alumina and α-Al2O3 nanofillers were synthesized from recycled aluminum beverage cans through acid dissolution, carbonate precipitation, and phase-selective calcination at 600 °C and 1200 °C, then functionalized with 3-aminopropyltriethoxysilane (APTES) and dispersed in epoxy at 1–7 wt%. Using a common recycled precursor provides a controlled basis for comparing the phase-dependent behavior of γ-rich alumina and α-Al2O3. Surface resistivity, surface potential mapping, isothermal surface potential decay (ISPD) trap analysis, DC flashover testing, and coupled electrothermal COMSOL simulation were performed. Among the investigated loadings, 5 wt% produced the highest surface resistivity for both alumina phases and was therefore selected for detailed electrical characterization. The γ-rich phase, with its defective spinel structure, gave the highest surface resistivity gain (68.1%) and mean flashover voltage (13.49 kV, +12.8% versus neat epoxy), whereas the corundum-structured α phase showed faster early charge dissipation (44.0% within 15 min) from a shallow-trap density more than double that of γ-rich alumina. Simulation showed γ-rich alumina cut accumulated charge by 61.8% and the peak triple-junction field by 23.1% after 120 s. The results demonstrate that calcination-induced structural modification of recycled alumina provides a controllable and sustainability-driven route for regulating HVDC surface-insulation performance.
The circular use of end-of-life lithium-ion battery cathodes as catalysts can connect
electronic-waste management with renewable-fuel production. This study extends
previously reported route-selection and cathode-nanosizing work by applying a KOHfunctionalized LiCoO₂-rich recovered oxide to the transesterification of C...
Vivek R. Sharma, VARUN PRATAP SINGH, Siddharth Jain et al.· International journal of res...· 0 citations
Deep sulfur removal from real refinery kerosene was systematically investigated using a bimetallic Eu–Mn/rGO-700 catalyst prepared on a carbonaceous support derived from discarded advertising-poster plastic waste and exhibiting structural characteristics associated with reduced graphene oxide (rGO). The waste precursor...
Othman R. Hussain, A. Nawaf, A. Jarullah et al.· Catalysts· 0 citations
Biochars derived from sunflower hulls and rice husks were chemically activated with chitosan/NaOH and investigated as electrochemical interfaces for trace-metal determination. The treatment improved electrode wettability, charge-transfer properties, and electrochemically accessible surface area, while favouring the in...
M. Mosquera-Ortega, V. Špada, J. Bilić et al.· Talanta: The International J...· 0 citations
The second part of this study provides a physicochemical substantiation of the degradation processes in aluminosilicate refractories upon contact with high-alkaline plant-based ash. Based on the analysis of the ternary phase diagrams of the K2O–Al2O3–SiO2 system, a fundamental vulnerability of typical industrial refrac...
V. Gonchar, L. Trotsenko, O. Sezonenko et al.· Energy Technologies & Re...· 0 citations
Copper-containing electroplating wastewater is strongly acidic and highly saline, making efficient treatment challenging. Oxalic-acid-modified sugarcane bagasse biochar was prepared as an anode-side flow electrode for asymmetric flow-electrode capacitive deionization (AFCDI). Sugarcane bagasse biochar modified with 1.2...
Jiang-Nan Peng, Qi-Yu Li, Wei Liu et al.· Water· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.